The solution for solving the line broken off the scrubber /cleaning ball-making machine

Then a lot of new friends contacted me and put forward a variety of questions, which asked the most about the steel scrubber-making machine production problems, stainless steel wire is easy to break, can not find the start, waste a lot, how to solve it?

This situation greatly affects our production and processing efficiency. In order to minimize the occurrence of this situation, I summarize the following reasons and solutions for you:

1: pressure wheel reason, pressure wheel after a long time of work, there are many large and small pits on the surface, resulting in steel wire through the pit when the damage, will be broken after the blade.

Solution:

the pressure wheel behind the steel wire replacement position.

Replace the pressure wheel.

2: blade reason, blade after a long time of wear, there will be a ditch, when the wire is flattened the trench mark is more expansive, and the wire will be stuck here and can not pass, resulting in a broken line.

Solution:

1. Remove the blade for polishing;

2. Replace the blade with a new one

3: guide wheel reason: the guide wheel after a long time of wear will be worn out with groove marks, when the flattened steel wire reaches here will be stuck, resulting in a broken line, or lead to the rubber wheel can not draw normally.

Solution: 1. Replace the guide wheel.

2. Loosen the nut and rotate the guide wheel.

The above three are common situations, there may be other reasons, welcome to leave a message if you encounter questions, I will be the first time to reply to you, thank you for your reading.

Edited by Santos Wang from Ningbo Master Clean Commodities Co.,Ltd.    

https://www.masterscourer.com    

santos@mastescourer.com    

86-18958238181